Debugging and Testing Techniques

Debugging and Testing Techniques

Using the assert Command

The assert command is used for program debugging purposes: to display a message dialog with options when a condition evaluates to False (.F.).

assert <condition as logical> [message <message as character>]

The message box has four buttons, offering the following options:

Button	Option
Debug	Suspends program execution and starts the Debugger. The Debug option is only available if the program is being run uncompiled.
Cancel	Stops program execution.
Ignore	Continues program execution.
Ignore All	Continues program execution and issue set asserts off, causing subsequent asserts to be ignored.

Using the Workbench Debugger

The debug command displays a pop-up debugger allowing the specified program to be monitored during execution.

debug <filename as character>

The debugger consists of four lines of information about the current program and eighteen push buttons. Program information consists of the following lines:

OPERATION	Displays one of the following DEBUG operations: STEP, BREAKPOINT or WATCHPOINT.
PROGRAM	Displays the name of the current procedure or program.
LINE#	Displays the current line number.
COMMAND	Displays the next program line to be executed.

The eighteen push buttons are used to access information about the current environment and to specify memory variables and conditions to monitor during program execution. The pop-up debugger provides the following push buttons:

BUTTON	EFFECT
Step	Step through a line at a time.
Suspend	Suspend the program to go to the interactive prompt, RESUME to restart.
Cancel	Cancel program execution and create error.mem.
Memory	Display currently declared memory variables.
Status	Display currently open tables (and their indexes, current record, etc.).
Calls	Show program/procedure call stack.
Watch	Set a watch point. When Executing the program, execution will stop when the specified memory variable's value changes.
Break	Set a break point. When Executing the program, execution will stop when the specified condition becomes true.
History	Show command history trace.
Execute	Run program without stepping until watch point or break point reached.
Wpclear	Clear all watch points.
Bpclear	Clear all break points.
Bpmark	Mark the current line as a break point.
Bpdrop	Clear a particular break point.
Wpdrop	Clear a particular watch point.
Bpshow	Show all break points.
Wpshow	Show all watch points.
Quit	Exit the program and debugger.

Use the [UP], [DOWN], [LEFT], and [RIGHT] arrow keys to navigate the push buttons, and press the [RETURN] key to select a button. You may also type the accelerator key to select a button. The accelerator keys are the highlighted letters in the label of each push button.